Fusion of in-situ and spaceborne sensing for environmental monitoring

<p>Measuring soil reflectance in the field, rather than in a laboratory setting, can be very useful when it comes to numerous applications such as mapping the distribution of various soil properties, especially when prompt estimations are needed. &#160;Recent advances in spectroscopy, and specifically in the development of low-cost Micro-Electro-Mechanical-Systems (MEMS) based spectrometers, pave the way for developing real-time applications in agriculture and environmental monitoring. Compared to high-end spectrometers, whose spectral range extends from Visible (VIS) and Near-InfraRed (NIR) to Shortwave InfraRed (SWIR), MEMS cover limited parts of the electromagnetic spectrum resulting in missing important information. In parallel, new space missions such as Planet Fusion are operationally ready and provide optical imagery (RGB and NIR) with high spatial (3m) and temporal (daily) resolution. To this end, we assessed the potential of augmenting the bands captured from a commercial MEMS sensor (Spectral Engines Nirone S2.2 @ 1750 &#8211; 2150 nm) by adjoining the Planet Fusion bands at the exact sampling date and location that in-situ scans originate.</p><p>Employing the above, a set of portable MEMS was used at a pilot area in Cyprus (Agia Varvara, Nicosia district) to develop a regional in-situ Soil Spectral Library (SSL). A set of 60 distinct locations were selected for capturing in situ spectral reflectance after the stratification of Planet Fusion pixels of the pilot area, while a physical soil sample was analyzed at the laboratory for the determination of Soil Organic Carbon (SOC) content. During the visit, topsoil moisture was also measured.</p><p>The resulting SSL, containing the in-situ spectra, SOC, and moisture content was further augmented by the 4 bands of Planet Fusion imagery acquired on the exact date of the field visit. At this stage, three Random Forest models for SOC content estimation were fitted using as explanatory variables initially only the MEMS data with moisture content, then Planet Fusion bands, and finally all three available inputs.</p><p>The results presented an observable decrease in RMSE of SOC content estimations when fusing in-situ with spaceborne data, highlighting the importance of the information contained at VIS-NIR when modeling SOC. On the other hand, the synergy of the two sensors is mutually beneficial; SOC absorption bands can also be found in the SWIR region and are hard to detect with remote sensing means since they fall within the strong water absorption region (around 1950 nm). MEMS-based systems operating at the SWIR part can support this process, and if combined with ancillary environmental measurements such as soil moisture, can provide a cost-effective solution for measuring SOC and other soil-related parameters. To loosen the necessity of laboratory analysis, it is necessary to establish protocols and guidelines for spectral data collection and management to ensure that the data collected is consistent and of high quality and develop representative SSLs that can be used to serve different modeling scenarios.&#160;</p>