Cross-Laminated Timber Panels Produced from Low-Grade Yellow- Poplar Sorted by Structural Visual Grade

Low-grade yellow-poplar (Liriodendron tulipifera) graded No. 2 Common, and No. 3 Common (National Hardwood Lumber Association -NHLA rules) is mainly used by the industry to produce wood pallets. Cross-laminated timber (CLT) panels are options to diversify the usage and increase the value of this material. Therefore, the objective of this study was to produce CLT panels from a population of NHLA graded No. 2A, No. 2B, No. 3A, and No. 3B lumber and to evaluate whether the panel properties meet the bending criteria (major strength direction) and adhesive bond requirements listed for "V"type CLT in ANSI/APA PRG 320-2019 (2020) using Northeastern Lumber Association Manufacturers No. 2 and No. 3 in longitudinal and transverse layers, respectively. Ten panels were produced to evaluate the bond quality and mechanical properties. The bond test results showed average delamination under 5 percent and were more frequent in the central areas of the panel than in the outer panel areas. The results from testing showed that the calculated allowable stress-design bending-strength (major direction) value for the yellow-poplar CLT panels was 1,718 psi (11.84 MPa), which corresponds to a value 90 percent higher than V1 (900 psi, 6.20 MPa) layups. Modulus of elasticity (MOE; major direction) was comparable to V2 and V3, with an average MOE of 1.39 by 106 psi (9,584 MPa). Based on these findings, the study indicated the potential for using low-grade yellow-poplar lumber to produce CLT panels. However, more research is needed to evaluate other mechanical properties in both the major and minor axis.