Radiographic evaluation of the tenting screw technique in horizontal alveolar bone augmentation: A retrospective study

ObjectivesTo radiographically analyze the effects of tenting screw technique (TS) and onlay bone grafts (OG) in horizontal bone augmentation. Materials and MethodsPatients receiving horizontal bone augmentation by TS or OG were selected. The clinical outcomes and cone beam computed tomography (CBCT) data were documented pre-grafting, immediately post-grafting, before and after implantation. The survival rates, clinical complications, alveolar bone width, and volumetric bone augmentation were evaluated and statistically analyzed. ResultsA total of 25 patients and 41 implants were involved in this study, with no grafting failures observed in either the TS group (n = 20) or the onlay group (n = 21). Volumetric bone resorption rate in the TS group (21.34%) was significantly lower than that of the OG group (29.38%). In addition, significant horizontal bone gain was achieved in both groups (TS: 6.15 +/- 2.12 mm; OG: 4.86 +/- 1.40 mm) during the recovery period, with higher gain in the TS group. No apparent statistical difference in terms of volumetric bone gain was observed between the TS (748.53 mm(3), 607.47 mm(3)) and OG group (811.77 mm(3), 508.49 mm(3)) immediately post-grafting or after the recovery period. ConclusionBoth TS and OG achieved satisfactory bone augmentation effects, yet TS resulted in more bone augmentation and better stability than OG, with a reduced use of autogenous bone. Overall, the tenting screw technique can serve as an effective alternative to autogenous bone grafts.