Parametric and modelling study of H2O-induced plasticization in PEI-TFC membrane for gas dehydration

Separation of moisture from gaseous mixtures, such as natural gas, humid air in food and goods storage ware-houses or in sports halls and so on is of great importance. In this article, the separation of water from a wet gas stream is carried out by a TFC membrane made by interfacial polymerization on the sublayer of porous poly-etherimide hollow fibers. Then the key-parameters affecting membrane efficiency is studied. The outcomes show that increasing the concentration of MPD has a substantial effect on enhancing the membrane water vapor flux. Moreover, it is disclose that increasing the concentration of TMC has the greatest effect on reducing nitrogen gas permeability and increasing the selectivity. Our findings reveals that disregarding the very low concentration of water vapor in the feed, shows a great impact on the permeance of each component compared to the pure state. Also, based on the modelling, it is obvious that for nitrogen gas in the entire pressure range, the adsorption mechanism is almost completely controlled by the Henry model, while the Langmuir adsorption mechanism is controlling for water vapor at low pressures, although at high pressures, the Henry mechanism has absolute superiority. Surprisingly, the H2O-induced plasticization impact on nitrogen permeance is more intense than on water vapor permeance. According to the modeling outputs, it is revealed that because D N2 is one to two order of magnitude lower than DH2O, water vapor permeance is much higher than that of nitrogen.