Rate of Splashes When Opening Microfuge Tubes with Various Methods

Introduction: Snap-cap microcentrifuge tubes are ubiquitous in biological laboratories. However, limited data are available on how frequently splashes occur when opening them. These data would be valuable for biorisk management in the laboratory.Methods: The frequency of splashes from opening snap-cap tubes using four different methods was tested. The splash frequency for each method was measured on the benchtop surface and on the experimenter's gloves and smock, using a Glo Germ solution as a tracer.Results: Splashes occurred very frequently when opening microcentrifuge snap-cap tubes, no matter which method was used to open the tube. The highest rate of splashes on all surfaces was observed with the one-handed (OH) opening method compared with two-handed methods. Across all methods, the highest rate of splashes was observed on the opener's gloves (70-97%) compared with the benchtop (2-40%) or the body of the researcher (0-7%).Conclusions: All tube opening methods we studied frequently caused splashes, with the OH method being the most error-prone but no two-handed method being clearly superior to any other. In addition to posing an exposure risk to laboratory personnel, experimental repeatability may be affected due to loss of volume when using snap-cap tubes. The rate of splashes underscores the importance of secondary containment, personal protective equipment, and good protocols for decontamination. When working with especially hazardous materials, alternatives to snap-cap tubes (such as screw cap tubes) should be strongly considered. Future studies can examine other methods of opening snap-cap tubes to determine whether a truly safe method exists.