Investigating the Impact of Fly Ash on the Strength and Micro-Structure of Concrete during Steam Curing and Subsequent Stages.

Steam curing, a common way of curing precast concrete, can greatly improve its 1-day strength. However, the thermal effect of prolonged high-temperature curing can negatively impact the concrete's performance, thus compromising production of precast products in cold regions. Fly ash (FA) is used as a supplementary cementitious material to improve part of the properties of concrete. In this paper, we investigated the effect of FA (10~30%) on the compressive strength and microstructure of manufactured sand concrete at the steam curing and later stages. Specifically, we analyzed the behavior of FA in the constant temperature phase under steam curing. Results indicated that the pozzolanic reaction of FA started to occur at 24 h of constant temperature curing. Early hydration under steam curing produces a large amount of Ca(OH), causing the pozzolanic reaction of FA to occur significantly earlier, and the high pH value of the solution and the fibrous mesh structure of the FA surface promote the pozzolanic reaction. The addition of 30% FA to manufactured sand concrete causes a significant reduction in early strength under steam curing, which is not beneficial to the formwork removal and tensioning of precast members. Notably, manufactured sand concrete with 20% FA under steam curing had the highest late strength. The filling effect of FA and the additional gel produced by the pozzolanic reaction would result in the reduction in large pore content, refinement of pore size, improvement of microstructural compactness, and increase in gel system strength. Therefore, the addition of 20% FA to the manufactured sand concrete can improve the long-term strength, which is beneficial to the production of precast beams in cold regions.