Comparison of Alkaline Sulfite Pretreatment and Acid Sulfite Pretreatment with Low Chemical Loading in Saccharification of Poplar

Sulfite pretreatment is a productive process for lignin dissolution in lignocelluloses and to reduce the hydrophobicity of lignin by sulfonation, thus promoting the hydrolyzability of the substrate. Previously, sulfite pretreatment needs high dosages of chemicals and thus results in the high cost of the pretreatment and the great pressure of environmental pollution. To overcome these problems, it was crucial to research whether alkaline sulfite pretreatment (ALS) and acid sulfite pretreatment (ACS) with low chemical loading could enhance the saccharification of poplar. In this work, the results indicated that with low loading of chemicals in sulfite pretreatment, ALS pretreatment (1.6% Na 2 SO 3 and 0.5% NaOH) at 180 °C removed more lignin, resulted in lower hydrophobicity and higher cellulase adsorption capacity of poplar than ACS pretreatment (1.6% Na 2 SO 3 and 0.5% H 2 SO 4 ) at 180 °C. A satisfying glucose yield of 84.9% and a xylose yield of 76.0% were obtained from poplar after ALS pretreatment with 1.6% Na 2 SO 3 and 0.5% NaOH at 180 °C for 1 h using 10 FPU cellulase/g dry matter, saving sodium sulfite by 60.0% compared to the loading of sulfite in traditional sulfite pretreatment. The strategy developed in this work reduced chemical loading and cellulase loading in alkali sulfite pretreatment for the saccharification of poplar.