Simultaneous Retrieval of Trace Gases, Aerosols, and Cirrus Using RemoTAP—The Global Orbit Ensemble Study for the CO2M Mission

In support of the Copernicus Anthropogenic Carbon Dioxide Monitoring (CO2M) mission, this study evaluates the performance of the Remote sensing of Trace gas and Aerosol Product (RemoTAP) algorithm based on synthetic orbit measurements of realistic atmospheric and geophysical scenes over land. To make use of the added value of the multi-angle polarimeter (MAP) aboard the CO2M mission, the RemoTAP algorithm is developed to perform simultaneous retrieval of trace gas and aerosol properties from both MAP and CO2 imager (CO2I) measurements. At the same time, it has the capability to perform the retrieval of trace gas from only CO2I measurements. To set up the baseline tests, we apply a simple filter based on non-scattering retrievals in different CO2I bands which is able to filter out 80% of the cirrus-contaminated pixels, and after posterior filtering based on goodness of fit, 95% of the cirrus-contaminated cases are screened out. The MAP-CO2I retrieval method is able to reduce the aerosol-induced retrieval error in column-averaged dry-air mole fraction of CO2 (XCO2) in terms of RMSE and bias by more than a factor of 2, compared to CO2I-only retrievals on the filtered pixels. A strong correlation between XCO2 error and surface albedo in CO2I-only retrievals is significantly reduced for MAP-CO2I retrievals. Moreover, XCO2 biases in CO2I-only retrievals exhibit a significant spatiotemporal variability caused by a strong dependence on aerosol load. The biases can be up to 2 ppm over some regions, which are much larger than for the global case. It shows that only by the inclusion of MAP measurements, the large aerosol-induced biases can be mitigated, resulting in the retrievals that meet the mission requirement (precision <0.7 ppm and bias <0.5 ppm). The error estimates for XCO2 retrievals cover the uncertainties related to the instrument, aerosol, and cirrus, although other error sources, for example, in temperature and pressure profiles, may increase the overall error somewhat. The impact of cirrus on the retrieval, which can be significant, is also investigated. When not accounted for in the retrieval, the presence of a thin layer of cirrus with an optical thickness at 550 nm smaller than 0.3 can increase XCO2 errors by a factor of about 3 for MAP-CO2I retrievals, leading to an RMSE of 2.3 ppm for cirrus-contaminated scenes. When fitting cirrus properties, this can be reduced to 1.27 ppm for cirrus-contaminated cases. For CO2 retrievals using the proxy method, in a highly idealized situation where it is assumed that a perfect CH4 prior is available, an RMSE of 0.93 ppm and a bias of 0.3 ppm are achieved. These retrievals are hardly influenced by cirrus but depend linearly on the accuracy of the CH4 prior.