Direct thrust test and asymmetric performance of porous ionic liquid electrospray thruster

In order to meet the demand of CubeSats for low power and high-performance micro-propulsion system, a porous ionic liquid electrospray thruster prototype is developed in this study. 10 × 10 conical emitter arrays are fabricated on an area of 3.24 cm2 by computer numerical control machining technology. The propellant is 1-ethyl-3-methylimidazolium tetrafluoroborate. The overall dimension of the assembled prototype is 3 cm × 3 cm × 1 cm, with a total weight of about 15 g (with propellant). The performance of this prototype is tested under vacuum. The results show that it can work in the voltage range of ±2.0 kV to ±3.0 kV, and the maximum emission current and input power are about 355 μA and 1.12 W. Time of Flight (TOF) mass spectrometry results show that cationic monomers and dimers dominate the beam in positive mode, while a higher proportion of higher-order solvated ion clusters in negative mode. The maximum specific impulse is 2992 s in positive mode and 849 s in negative mode. The thrust is measured in two methods: one is calculated by TOF results and the other is directly measured by high-precision torsional thrust stand. The thrust (T) obtained by these two methods conforms to a certain scaling law with respect to the emission current (Iem) and the applied voltage (Vapp), following the scale of T ∼ IemVapp0.5, and the thrust range is from 2.1 μN to 42.6 μN. Many thruster performance parameters are significantly different in positive and negative modes. We speculate that due to the higher solvation energy of the anion, more solvated ion clusters are formed rather than pure ions under the same electric field. It may help to improve thruster performance if porous materials with smaller pore sizes are used as reservoirs. Although there are still many problems, most of the performance parameters of ILET-3 are good, which can theoretically meet the requirements of CubeSats for micro-propulsion system.