Research on Bending Performance of Three-Dimensional Deep Angle Interlock Kevlar/EP Armor Material

Three-dimensional (3D) woven composites have attracted much attention in the lightweight research of protective armor due to their high specific strength and good impact resistance. However, there are still many gaps in terms of the performance and influencing factors of three-dimensional deep-angle-interlock (3DDAI) Kevlar/EP armor materials. Therefore, in order to prepare 3DDAI Kevlar/EP armor materials with excellent ballistic resistance and mechanical properties, this paper studies the bending performance of 3DDAI Kevlar/EP armor materials and the influence of the number of stacking layers, resin content, laying method, and weft density. Finally, we compare it with the traditional two-dimensional (2D) plain laminated Kevlar/EP armor material. The results showed that when the 3DDAI Kevlar/EP armor material was subjected to bending load, the upper and bottom layers of the material had a great influence on the initial stiffness and fracture strength of the material, respectively; when the material's warp and weft density are quite different, the utilization rate of the yarn and the strength of the material are negatively affected; the fracture energy of the 3DDAI Kevlar/EP armor material prepared by the orthogonal laying method was about 20% higher than that of the 3DDAI Kevlar/EP armor material with the unidirectional layering method; and the bending performance of the 3DDAI Kevlar/EP armor material in the weft direction was better than that of the 2D plain laminated Kevlar/EP armor material, with the 3DDAI Kevlar/EP armor material having better delamination resistance. The research results will lay the foundation for structural optimization and engineering applications of such materials.