Precision of In Vivo Quantitative Tooth Wear Measurement using Intra-Oral Scans.

Quantitative wear measurement is of increasing interest for measuring tooth wear progression. However, most research on quantitative wear measurement has focused on simulated wear or scanned gypsum casts. A 3D Wear Analysis (3DWA) protocol has been developed that analyzes tooth wear in vivo through intra-oral scanners available to dental clinicians. This study investigated the precision of the 3DWA protocol for measuring wear through maximum height loss (mm) and volume change (mm3). Observational prospective wear data from 55 patients were analyzed after 0-1-, 0-3-, and 0-5-year intervals to determine rates of wear, and convenience samples were chosen to test the protocol's precision on dentitions scanned twice in one sitting and its intra- and inter-rater precision on scans with 0-3- and 0-5-year intervals. Scans were made using intra-oral scanners (IOS) and superimposed using 3D measurement software. T-tests were performed to determine the structural and random error, and trimmed ranges were calculated to interpret the error. For protocol precision, the mean difference was 0.015 mm (-0.002; 0.032, p = 0.076) for height and -0.111 mm3 (-0.250; 0.023, p = 0.101) for volume. The duplicate measurement error was 0.062 mm for height and 0.268 mm3 for volume. The height measurements were precise enough to measure wear after intervals of 0-3 or 0-5 years; however, volume measurements were susceptible to procedural error and operator sensitivity. The 3DWA protocol is precise enough to adequately measure tooth height loss after intervals of a minimum of 3 years or in patients with severe wear progression, but it is not suited to measuring volumetric changes.