A strategy to design Ti-based in-situ bulk metallic glass composites containing controllable volume fraction and composition of the dendrite phase using conventional titanium alloy Ti-6Al-4V

Up to now, the composition design in the field of Ti-based in-situ dendrite reinforced bulk metallic glass composites (BMGCs) has been a great challenge. In this work, a simple but effective strategy is proposed to tailor the dendrite composition and volume fraction by using conventional Titanium alloy Ti-6Al-4V, and a series of in-situ dendrite reinforced BMGCs (Z1-Z4) are prepared based on it. The dendrite volume fraction can be adjusted by changing the proportion of the Titanium alloy Ti-6Al-4V, while the compositions of the dendrites are highly correlated with Ti-6Al-4V. In these alloys, with the increase of the mass percent of the added Titanium alloy Ti-6Al-4V, the volume fraction of the dendrite phase increases monotonically from Z1 to Z4 alloy. Z1 alloy behaves like a BMG with a high yield strength and limited plasticity due to its small dendrite size. Z2-Z4 alloys show excellent plasticity and significant work-hardening ability, because the dendrite size is appropriate and the dendrites undergo stress-induced martensite transformation during compression. From Z2 to Z4 alloy, with the increase of dendrite volume fraction from 56% to 78%, the yield strength does not decrease, which is due to the gradually enhanced stability of the dendrites. This composition design strategy is effective and universal, which can provide a new perspective for the composition design and development of TiZrbased in-situ dendrite reinforced BMGCs. (c) 2022 The Authors. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license (http://creativecommons.org/licenses/by-nc-nd/4.0/).