A regional ionospheric assimilation study with GPS and COSMIC measurements using a 3D-var algorithm (IDA4D)

The Ionospheric Data Assimilation Four-Dimension (IDA4D) is, developed by Bust et al. (2007), a continuous time and three-dimension variational (3D-Var) algorithm that can optimally estimate the ionosphere from a model and measured data. In this study, we utilized three different data types into IDA4D for a regional ionosphere estimation: slant total electron contents (STEC) obtained from a Global Positioning System (GPS) network, NmF2 (peak electron density of the F2 layer) and STEC from Constellation Observing System for Meteorology, Ionosphere and Climate (COSMIC) satellite. These multiple type data were assimilated into a background model, the International Reference Ionosphere (IRI – 2016). To evaluate the effect of each data type, the assimilation was performed on the following data combinations (cases): (1) GPS-STEC’s only; (2) GPS-STEC’s and NmF2′s from COSMIC; (3) GPS-STEC’s and COSMIC-STEC’s; and (4) all three data types. For each case computed foF2′s (F2 layer critical frequency) from IDA4D were compared with measured values from five ionosondes (I-Cheon, Jeju, Okinawa, Kokubunji, and Wakkanai) in the region of Korea and vicinities for the test periods of March, June, September and December in 2015. The comparison shows that computed foF2′s for all cases have higher correlation coefficients (CC) and less root mean square errors (RMSE) from measured values than IRI estimated values. In Cases 2, 3 and 4, IDA4D performance progressively improved in areas where GPS measurements were not covered but COSMIC STEC and NmF2 data were available. Furthermore, the IDA4D assimilation yields better results for electron density profiles and TEC values in comparison with observed values than the IRI model does. Thus, our study suggests that the IDA4D model with multiple data types can provide a reliable estimation of the regional ionosphere over the Korean Peninsula and vicinities.