Experimental and numerical analysis of fine particle and soot formation in a modern 100 MW pulverized biomass heating plant

The formation of soot, organic, and inorganic aerosols has a profound effect on the environmental and technological feasibility of biomass combustion. In this work, the soot and aerosol processes are examined for a modern pulverized wood-burning 100 MWth district heating plant. Experimental data was collected from two locations inside the furnace (30% and 100% thermal loads), including measurements for fine particle (PM1) number size distribution, number concentration, and chemical composition. The experiments were complemented with Computational Fluid Dynamics (CFD) simulations and Plug-Flow Reactor (PFR) modeling. The measurements and modeling are combined in a comprehensive analysis, providing fundamental understanding on the aerosol processes inside the furnace. The wood-powder combustion is efficient under both thermal loads, indicated by the low unburned carbon content in fly-ash, and the low CO, NO and soot emissions (< 0.3 mg/Nm(3)). The fine particles consist mainly of K2SO4, and of lesser amounts of alkali salts (NaCl, KCl), and Ca and Mg compounds (oxides or sulfates). A large concentration of KOH/K2CO3 vapor may exist in the flue gas and play a significant role in the heat exchanger fouling. The applied modeling tools are shown to provide accurate estimations for the composition and formation regions of fine particles inside the industrial biomass furnaces. (C) 2021 The Authors. Published by Elsevier Inc. on behalf of The Combustion Institute.