Results of plasma radiative compression investigation in the PF-24 device operated with D2, Ar and (100%-x)D2+x%Ar mixtures obtained using the 5-phase Lee model code.

The article presents new results for plasma radiative compression in high-current discharges in the z-pinch configuration. The results are based on the 113 discharges performed in the plasma-focus PF-24 device operated with D2, Ar and (100%-x)D2+xAr mixtures, with Ar pressure fractions x ≈ 3-60% (mole fractions). The constant initial total pressure is about 2.9 mbar and the constant initial pressure of Ar is 1.2 mbar. Each experimental discharge was simulated individually using the 5-phase Lee model code to carry out the fitting procedure of the total discharge current waveform. The results from these 113 computed discharges fitted to the corresponding 113 experimental discharges show that the increase of the effective atomic number of the gas mixture increases the probability of occurrence of plasma radiative compression phenomenon. Relatively weak radiative compression was found for part of the discharges in 15-60% range of Ar mole fractions and in Ar, while the stronger radiative compression occurred for part of discharges in Ar only. This is because there was too little total x-ray line radiation emission during the equilibrium pinch lifetime related to the very small amount of swept up mass and the low current flow through pinched plasma, represented by the decreasing values of model parameters as the Ar mole fraction increases. The results show that the main pinch parameters influencing the occurrence and strength of radiative compression are: total x-ray line emission yield, effective atomic number, initial pinch radius, initial pinch ion number density and initial pinch ion/electron temperature.