Identification of fractures in tight-oil reservoirs: a case study of the Da'anzhai member in the central Sichuan Basin, SW China

The Da'anzhai Member of the Jurassic Ziliujing formation in central Sichuan is a typical tight-oil reservoir with porosity and permeability less than 2% and 0.1 × 10 –3 μm 2 , respectively. Fractures in this formation are well developed in micro- and nano-scale. However, the factors that control the fracture distribution are unclear. Additionally, the uncomprehensive and ineffective identification and evaluation of fractures in the early stage of tight-oil development makes it difficult to meet the requirements of tight-oil development. In our work, we used cores, thin sections, and a scanning electron microscope (SEM) to study the influence of the microscopic rock composition, including the shelly grains, calcite grains, and clastic grains, on the fracture development. We found that the microscopic composition of shelly grains and calcite grains separately control the development of inter-shelly fractures and shelly fractures, and intergranular fractures, and tectonic fractures. Except for a small number of dissolution fractures found in mudstone, the fractures are not well developed in the formations with clastic grains. According to the characteristics of the development degree of fracture and the resolution of the well-logs, the fractures are divided into large scale, small scale, and micro-scale. By a newly established level-by-level constraints method, we systematically identified the scale, occurrence, filling characteristics, and development degree of fractures in the Da'anzhai member by well-logs. Moreover, a quantitative model is also proposed for identifying the angles and development degree of fractures. The results show that the scale of fractures can be effectively identified by the shapes and values of resistivity logs; the occurrence, development, and filling characteristics of fractures can be semi-quantitatively evaluated by the relative amplitude difference between the matrix resistivity (R b ) and formation resistivity (R T ). The results are consistent with the interpretation results by formation micro-resistivity imaging (FMI) log, which further demonstrates that the level-by-level constraint method by conventional well-logs can be used to systematically and effectively predict the fracture characteristics in tight-oil reservoirs.