Improvement Of Mechanical Properties And Forming Efficiency During Hot Gas Forming Of Cfrp Curved Surface Components

Carbon fiber reinforced plastics (CFRP) are widely used in aerospace and new energy vehicles due to their high specific strength and flexible design ability. At present, the traditional forming process of CFRP curved surface components has problems of low mechanical properties and long processing time. In this paper, a new method of hot gas forming was proposed to obtain CFRP components. By applying high temperature and high-pressure gas on one side of CFRP, the material was forced to deform and solidify at the same time. A special device for hot gas forming was designed and developed. The curing behavior and mechanical properties of original CFRP plates were studied. The main defects and the corresponding control methods of hot gas forming parts were analyzed by forming spherical parts, and the feasibility of the hot gas forming process was verified. Taking the battery cover plate of a new energy vehicle as the research object, the influence of forming temperature, gas pressure, pressurization rate and other process parameters on the mechanical properties of complex CFRP components were analyzed. The mechanism of both strength and efficiency improvement was analyzed. The results showed that with the increasing of gas pressure, the tensile strength and forming efficiency of the CFRP curved components were improved obviously. Under reasonable forming parameters, the tensile strength of the obtained parts was increased by 37%, and the forming efficiency was increased by 58%. The fiber bundles were distributed more evenly and compactly under the hot gas forming. This showed that the use of hot gas forming had good potential in the preparation of high-performance CFRP parts, which was helpful to improve the processing efficiency and forming quality of CFRP curved parts in the aerospace and new energy automotive fields.