Improving Baltic Sea wave forecasts using modelled surface currents

Currents in the Baltic Sea are generally weak, but during strong winds they can grow high enough to affect the surface wave propagation and evolution. To evaluate the significance of wave-current interactions in the Baltic Sea, we conducted a study using the wave model WAM, comparing a run without surface currents to one with current forcing from a NEMO hydrodynamical model simulation. The overall changes to the wave field caused by currents were quite small. Changes of over 10 cm in significant wave height (SWH) or 1 s in the peak period ( T p ) occurred only in some areas and typically less than 3% of the time. Current refraction changed the SWH annual mean by up to 2 cm, but changes up to 60 cm were seen in the maximum values. T p had occasionally large changes due to shifts in the peak energy in two-peaked swell and wind-sea spectra. Including currents typically led to a stronger changes in swell energy compared to the changes in wind sea energy. A comparison with a wave buoy in the Gulf of Finland showed that this change in the swell energy improved the accuracy of the simulation in this narrow gulf. Current-induced refraction was most prominent near the coastal areas, where current speed occasionally exceeded 0.3 m/s. In general, SWH decreased in the coastal areas with strong currents and slightly increased in adjacent open sea areas. The current effects were most frequent in the Gulf of Finland, the Western Gotland Basin and the Åland Sea.