Erratum: Broadband Ground-Motion Simulation of 2016 Amatrice Earthquake, Central Italy

On 24 August 2016 at 01:36 UTC a M(L)6.0 earthquake struck several villages in central Italy, among which Accumoli, Amatrice and Arquata del Tronto. The earthquake was recorded by about 350 seismic stations, causing 299 fatalities and damage with macroseismic intensities up to 11. The maximum acceleration was observed at Amatrice station (AMT) reaching 916 cm s(-2) on E-W component, with epicentral distance of 15 km and Joyner and Boore distance to the fault surface (RJR) of less than a kilometre. Motivated by the high levels of observed ground motion and damage, we generate broad-band seismograms for engineering purposes by adopting a hybrid method. To infer the low frequency seismograms, we considered the kinematic slip model by Tinti et al. The high frequency seismograms were produced using a stochastic finite-fault model approach based on dynamic corner-frequency. Broadband synthetic time-series were therefore obtained by merging the low and high frequency seismograms. Simulated hybrid ground motions were compared both with the observed ground motions and the ground-motion prediction equations (GMPEs), to explore their performance and to retrieve the region-specific parameters endorsed for the simulations. In the near-fault area we observed that hybrid simulations have a higher capability to detect near source effects and to reproduce the source complexity than the use of GMPEs. Indeed, the general good consistency found between synthetic and observed ground motion (both in the time and frequency domain), suggests that the use of regional-specific source scaling and attenuation parameters together with the source complexity in hybrid simulations improves ground motion estimations. To include the site effect in stochastic simulations at selected stations, we tested the use of amplification curves derived from IIVRSs (horizontal-to-vertical response spectra) and from HVSRs (horizontal-to-vertical spectral ratios) rather than the use of generic curves according to NTC18 Italian seismic design code. We generally found a further reduction of residuals between observed and simulated both in terms of time histories and spectra.