Biomechanical effects following footstrike pattern modification using wearable sensors.

OBJECTIVES:This study sought to examine the biomechanical effects of an in-field sensor-based gait retraining program targeting footstrike pattern modification during level running, uphill running and downhill running. DESIGN:Quasi-experimental design. METHODS:Sixteen habitual rearfoot strikers were recruited. All participants underwent a baseline evaluation on an instrumented treadmill at their preferred running speeds on three slope settings. Participants were then instructed to modify their footstrike pattern from rearfoot to non-rearfoot strike with real-time audio biofeedback in an 8-session in-field gait retraining program. A reassessment was conducted to evaluate the post-training biomechanical effects. Footstrike pattern, footstrike angle, vertical instantaneous loading rate (VILR), stride length, cadence, and knee flexion angle at initial contact were measured and compared. RESULTS:No significant interaction was found between training and slope conditions for all tested variables. Significant main effects were observed for gait retraining (p-values≤0.02) and slopes (p-values≤0.01). After gait retraining, 75% of the participants modified their footstrike pattern during level running, but effects of footstrike pattern modification were inconsistent between slopes. During level running, participants exhibited a smaller footstrike angle (p≤0.01), reduced VILR (p≤0.01) and a larger knee flexion angle (p=0.01). Similar effects were found during uphill running, together with a shorter stride length (p=0.01) and an increased cadence (p≤0.01). However, during downhill running, no significant change in VILR was found (p=0.16), despite differences found in other biomechanical measurements (p-values=0.02-0.05). CONCLUSION:An 8-session in-field gait retraining program was effective in modifying footstrike pattern among runners, but discrepancies in VILR, stride length and cadence were found between slope conditions.