Salt Distribution and Potato Response to Irrigation Regimes under Varying Mulching Materials.

Water scarcity and frequent drought spells are becoming critical challenges to sustainable agricultural development, especially in arid and semiarid regions. Thus, this work aims to investigate the effect of deficit irrigation and varying mulching materials on soil moisture content, salt distribution, and potato yield. The experiment consisted of three irrigation regimes (I-100%, I-80%, and I-60%) of crop evapotranspiration (ETc), designated as I-100%, I-80%, and I(60%)of ETc, and five mulching treatments viz. (i) without mulch (WM), (ii) poultry manure mulch (PMM), (iii) rice straw mulch (RSM), (iv) white plastic mulch (WPM), and (v) black plastic mulch (BPM), which were continued for two consecutive growing seasons. The results showed that soil salinity was affected by mulching and irrigation levels as the salt content increased from the initial soil salinity. Moreover, I(60%)recorded the highest salt accumulation in the soil profile for WM treatment compared to the rest of the irrigation and mulching treatments. It was also revealed that PMM remained unmatched by significantly producing the highest potato yield compared to other mulching materials. However, the average potato yield decreased by 13.83% and 29.16% in the 2016 season for I-80% and I(60%)and by 12.95% and 30.91% in the 2017 season, respectively, in comparison to full irrigation (I100%). So, when sufficient irrigation water is available, full irrigation (I-100%) and PMM treatment are recommended to achieve the maximum potato tuber yield, which has a minimum impact on increasing salinity. However, when the discharge is insufficient, deficit irrigation (I-80%) and PMM treatment are recommended to conserve 20% of the irrigation water applied with a minimum reduction in tuber yield and a slight increase in soil salinity.