Use of a 3D finite element model for post fumigation phosphine movement analysis: Presentation

Phosphine is a dangerous gas commonly used in fumigations throughout the world. Grain that has not fully released the phosphine it absorbed during fumigation may continue to desorb phosphine into the headspace of a storage structure. U.S. OSHA standards for handling phosphine state the acceptable limit at 0.3 ppm. If this limit is exceeded grain handling may become dangerous. It is important to understand the process of phosphine venting and desorption in order to ensure safe handling of fumigated grain in silos and during shipments. In order to achieve this, the venting and release of phosphine was studied on location in a well-sealed grain silo in Lake Grace, Western Australia, to serve as a set of data for verification of a computational model. This situation was then modeled using a 3D finite element model and compared to the real world results. Results were calculated using two fumigant desorption models based on previous literature, a reversed sorption model and an air-grain equilibrium model. Simulations reproduced accurate trends of desorption but did not accurately reproduce the quantity of fumigant, with a 55.5% error for the model based on reversed sorption equations and 86.3% error for the air-grain equilibrium based model. For both models, simulations were conducted to compare the effectiveness of existing grain venting regulations at producing grain that is within safe handling limits. These results highlight the necessity for continued desorption research and the importance of following venting guidelines.