Microstructure, dielectric and enhanced multiferroic properties of Fe 3 O 4 /PbZr 0.52 Ti 0.48 O 3 composite ceramics

Magnetoelectric composite ceramics Fe 3 O 4 /PbZr 0.52 Ti 0.48 O 3 with different molar ratios (Fe 3 O 4 /PbZr 0.52 Ti 0.48 O 3 = 1:1, 1:2 and 1:8) were prepared by combining hydrothermal method and sol–gel method, effects of molar ratio on the structure, dielectric and multiferroic properties were investigated. The results indicate that the synthesized composites show bi-phase structure, ruling out the presence of any obvious impurity phases. The grains can be divided into two types, the larger grain is attributed to PbZr 0.52 Ti 0.48 O 3 while the smaller one can be considered to be Fe 3 O 4 . With the molar ratio increasing, the grain shape of PbZr 0.52 Ti 0.48 O 3 changes from stripe to bulk-like while the shape and size of Fe 3 O 4 is near the same. Both the dielectric constant and loss decrease with frequency, the specimen with the molar ratio of 1:8 shows the largest dielectric constant, while the sample has the lowest dielectric loss when the molar ratio is 1:2. With the increase of molar ratio, the height of the relaxation peak decreases and the peak position shifts to higher temperature. When the molar ratio is 1:8, the relaxation peak disappears due to less interface polarization. The remnant polarization increases with increasing the molar ratio, the maximum value is 1.12 μC/cm 2 , obtained at 1 kHz when the molar ratio is 1:8. Anomalous magnetic properties are observed, in which the magnetization increases first and then decreases with molar ratio, the largest saturation magnetization is ~ 30 emu/g when the ratio is 1:2 due to the strong interface interaction. The sample with the ratio of 1:1 shows the largest magnetic loss because of the highest content of magnetic phase. The magnetization shows a monotonic variation behavior with the molar ratio, indicating the strong interface interaction between the two phases. The maximal ME coupling coefficient is about 5.12 mV/(cm.Oe) for the sample 1:2 due to the stronger magnetic and ferroelectric properties.