Investigation of a novel prosthesis technique for extracapsular stabilization of cranial cruciate ligament-deficient stifle joints in adult cattle.

OBJECTIVE To evaluate a novel prosthesis technique for extracapsular stabilization of cranial cruciate ligament (CCL)-deficient stifle joints in adult cattle. SAMPLE 13 cadaveric bovine stifle joint specimens. PROCEDURES In the first of 3 study phases, the most isometric points on the distal aspect of the femur (distal femur) and proximal aspect of the tibia (proximal tibia) were determined from measurements obtained from lateromedial radiographs of a stifle joint specimen maintained at angles of 135 degrees, 90 degrees, 65 degrees, and 35 degrees. During phase 2, 800-lb-test monofilament nylon leader line was cut into 73-cm-long segments. Each segment was secured in a loop by use of 2, 3, or 4 crimping sleeves such that there were 12 replicates for each construct. Each loop was distracted to failure at a constant rate of 1 mm/s. Mean force at failure and elongation and mode of failure were compared among the 3 constructs. During phase 3, bone tunnels were created in the distal femur and proximal tibia at the isometric points identified during phase 1 in each of 12 CCL-deficient stifle joint specimens. The 3-sleeve construct was applied to each specimen. Specimens were distracted to failure at a constant rate of 1 mm/s. RESULTS Among the 3 constructs evaluated, the 3-sleeve construct was considered optimal in terms of strength and amount of foreign material. In phase 3, all replicates failed because of suture slippage. CONCLUSIONS AND CLINICAL RELEVANCE Use of 800-lb-test monofilament nylon leader line as a prosthesis might be a viable alternative for extracapsular stabilization of CCL-deficient stifle joints in adult cattle. Further in vivo studies are necessary.