A New Calibration Method for Triaxial Fluxgate Magnetometer Based on Magnetic Shielding Room

The triaxial fluxgate magnetometers (TFMs) are widely used in space exploration, positioning and navigation, geological exploration, etc. As a high-precision vector magnetometer, the measurement accuracy will directly determine the accuracy of the obtained magnetic field data. The TFM has three kinds of own errors in measurement: zero offset error, proportional coefficient error, and nonorthogonal error. These three kinds of errors will cause the TFM to deviate from the actual magnetic field value, and the fluxgate magnetometer needs to be calibrated. At present, the accuracy of the calibration method adopted by the fluxgate magnetometer depends on the stability of the natural environment magnetic field and the triaxial turntable (there is an uncontrollable residual magnetic interference), which limits the further improvement of the calibration accuracy. And due to the wide application of electromagnetic equipment, the natural electromagnetic environment is further damaged, and the calibration accuracy is subject to deterioration. In this paper, a magnetic shielding room (MSR) is used to provide a near-zero magnetic environment, and a triaxial uniform magnetic field coil (TUMC) is installed inside the MSR to construct a controllable arbitrary vector direction magnetic field, which solves the magnetic field disturbance problem of the original method. The TUMC and TFM error models were built and the MSR magnetic ambient noise model was added. The emphasis is on the degree of distortion of the magnetic field generated by the MSR as a ferromagnetic boundary condition and the influence of the deviation of the center point of TUMC on the calibration accuracy. Then, based on the above error model and magnetic environmental conditions, the calibration accuracy of the calibration magnetic field distribution is analyzed. Finally, the calibration experiment of the TFM is carried out by using the existing MSR, which proves the feasibility and effectiveness of the calibration method, and the method can greatly improve the calibration efficiency.