Effects of hydrogen addition on non-premixed ignition of iso-octane by hot air in a diffusion layer

Hydrogen addition is widely used to improve the combustion performance of single-component fuel. In this study, the effects of hydrogen addition on non-premixed ignition of iso-octane by hot air in a diffusion layer were examined and interpreted numerically. Detailed chemistry and transport were considered in simulation. The non-premixed ignition delay times at different hydrogen blending levels were obtained and analyzed. It was found that hydrogen addition greatly reduces the ignition delay. This is mainly due to the fact that the preferential mass diffusion of hydrogen over iso-octane significantly increases the local hydrogen blending level at the ignition kernel. Besides, for the non-premixed ignition process, two modes of reaction front propagation were identified through the analysis based on Damköhler number and consumption speeds. One is the reaction-driven mode characterized by local or sequential homogeneous autoignition; and the other is the diffusion-driven mode, which depends on the balance of mass diffusion, heat transfer and chemical reaction. These two modes lead to different ignition behaviors. For pure iso-octane with low mass diffusivity, ignition is mainly caused by local homogeneous reaction occurring at the most reactive position. With the increase of diffusion layer thickness, the local temperature at the most reactive position increases and therefore the non-premixed ignition delay time of pure iso-octane decreases. However, when hydrogen with high mass diffusivity is added into iso-octane, the non-premixed ignition is controlled by fuel diffusion. With the increase of diffusion layer thickness, the concentration gradient becomes smaller and thereby less hydrogen diffuses into the ignition kernel. Consequently, unlike pure iso-octane, the non-premixed ignition delay time of hydrogen/iso-octane blends increases with the diffusion layer thickness.