The effect of glenoid component version and humeral polyethylene liner rotation on subluxation and impingement in reverse shoulder arthroplasty.

BACKGROUND:A previously validated finite element modeling approach was used to determine how changes in glenoid component version and polyethylene liner rotation within the humeral component affect the arm abduction angle at which impingement between the inferior glenoid and the polyethylene liner occurs as well as the amount of subluxation generated by that impingement. MATERIALS AND METHODS:Five glenoid component versions (5° anteversion; neutral; 5°, 10°, and 20° retroversion) and 7 polyethylene liner rotations (20° and 10° anterior; neutral; 10°, 20°, 30°, and 40° posterior) were considered, resulting in 35 different clinically representative models. The humerus was internally and externally rotated and extended and flexed, and the resulting impingement and subluxation were measured. To further analyze more global trends and to identify implantations least prone to subluxation, polyethylene liner rotation was additionally varied in coarser 30° increments across the entire 360° range. RESULTS:All subluxation caused by impingement occurred during external rotation and extension, and external rotation produced nearly 10-fold more subluxation than extension. Neutral glenoid component version was associated with the least amount of subluxation for all polyethylene liner rotations. Posteriorly rotated polyethylene liners, which place the thick inferior region of the component away from the scapula, produced the least amount of subluxation. The 90° and 120° posterior liner rotations produced no subluxation, whereas the 30° and 60° anterior liner rotations produced the greatest amount of subluxation. CONCLUSION:These results indicate that rotating modern radially asymmetric humeral polyethylene liners posteriorly can reduce the risk of subluxation leading to dislocation and increase external rotation range of motion.