Significant effect of the molecular formula in silver nanoparticle ink to the characteristics of fully gravure-printed carbon nanotube thin-film transistors on flexible polymer substrate

Single-walled carbon nanotubes (SWNTs) are a valuable material for use in not only nanoelectronics but also printed electronics because of their stability, tunable operation speed, and scalability. However, the device characteristics of fully printed, SWNT-based thin film transistors (SWNT-TFTs) often have large variations, and the fundamental cause of these inconsistencies are not yet well understood. Therefore, fully printed SWNT-TFT-based electronic devices have not been practically realized in the market. In this study, the significant variation in the electrical parameters of printed SWNT-TFTs that is caused by minor molecular variations in the formulation of silver nanoparticle-based ink is reported. Strikingly, a very small difference in the chemical structure between ethylene glycol and diethylene glycol in the silver nanoparticle-based ink, which is used to print drain-source electrodes in the SWNT-TFTs, with everything else identical, induced a difference of approximately 70 meV in the barrier height between the drain-source electrodes and the SWNT layer at 300 K. The modification of the absorbed polymer binder in the silver nanoparticle ink due to the additive is the major cause of the observed barrier height difference. These results allow for a better understanding of the relationship between the ink rheology at the molecular level and the printed device properties, and enable a more precise design and control of device properties which will have profound impacts on printed electronic devices.