Co-Evaporated Cuinse2: Influence Of Growth Temperature And Na On Solar Cell Performance

CuInSe2 films were prepared by a 3-stage-co-evaporation process. For Na-free absorbers we do not observe any influence of the preparation temperature between 330 degrees C and 510 degrees C on the solar cell performance with typical efficiencies around 9 %. NaF-PDT leads to an increase of the open-circuit voltage and the efficiency for samples prepared at a growth temperature of 450 degrees C and 510 degrees C (around 13 % for such samples). For samples prepared at 330 degrees C NaF-PDT has no influence on the open circuit voltage and the efficiency although the treatment increases the charge carrier concentration. At higher preparation temperatures, absorbers with Na present during growth (NaF-precursor samples) lead to similar IV parameters as NaF-PDT absorbers. NaF-precursor samples grown at temperatures at 330 degrees C, show an X-ray diffraction reflex, which is characteristic for the presence of twin stacking faults within the growing thin films. Solar cells with these absorbers show bad performances. In contrast, Na-free grown absorbers do not show twin stacking faults after the absorber growth process independently of the preparation temperature. Capacitance-voltage measurements give charge carrier concentrations of around 3x10(16) cm(-3) (NaF-precursor samples), 5x10(15) cm(-3) (NaF-PDT samples) and 6x10(14) cm(-3) (Na-free samples). From scanning electron microscopy it is deduced that Na, which is present during the growth, leads to films with smaller grain sizes.