A historic review on R & D of China's FCC riser termination device technologies

Fluid catalytic cracking (FCC) is a dominant refining conversion process in China's most refineries. After decades of development, China has already become one of the major FCC technology licensors in the world. In this review, the research and development (R&D) activities on FCC riser termination device (RTD) technologies in China are reviewed and discussed. Emphasis is put on the R&D of a series of advanced RTD technologies led by China University of Petroleum, Beijing, which initiated in the early 1990s when more and more China's FCC units chose to process more residue feedstock. Followed by the guideline of three "quick"s and two "high"s, two early types of RTD systems with coupled zones for gas-solids centrifugal separation and pre-stripping were developed and applied successfully in commercial units. Significantly reduced yields of coke and dry gas due to restrained post-riser reactions and satisfactory particle recovery efficiency were achieved. These were the fender-stripper cyclone and vortex quick separator systems designed for external-and internal-riser FCC units, respectively. Later, further improvement efforts led to the development of another two RTD systems, i.e. the circulating-stripper cyclone system for external-riser units and super vortex quick separator system for internal-riser units. By now, nearly 50 applications were commissioned with a sum FCC capacity of 40.0 Mton/a, nearly one-third of China's total FCC processing capacity. Besides, other research efforts, such as the geometry optimization efforts on LD2 type separator, the studies on RTD for down-flow riser FCC units, and the idea of non-disengager FCC unit are also discussed in this review. To accommodate to degraded feedstock, more stringent environmental regulations and new FCC process technologies, future R&D efforts on RTD technologies should be put on improvements to further satisfy the three-"quick"s and two-"high"s requirements with changing FCC operating conditions and different process requirements.