Effect of the yaw injection angle on the ECC bypass in comparison with the horizontal DVI

The comparison tests for the direct emergency core cooling (ECC) bypass fraction were experimentally performed with a typical direct vessel injection (DVI) nozzle and an ECC column nozzle having a yaw injection angle to the gravity axis. The ECC yaw injection nozzle is newly introduced to make an ECC water column in the downcomer region. The yaw injection angle of the ECC water relative to the gravity axis is varied from 0 to (±)90° stepped by 45°. The tests are performed in the air–water separate effect test facility (direct injection visualization and analysis (DIVA)), which is a 1/7.07 linearly scaled-down model of the APR1400 nuclear reactor. The test results show that (1) if the ECC water column is injected into the wake region which is induced by the hot leg blunt body in the downcomer annulus, the ECC bypass fraction is greatly reduced compared with the typical horizontal ECC injection which makes ECC film on the downcomer wall. At the same time, the ECC penetration toward the lower downcomer region becomes larger than those of a typical horizontal type of direct vessel injection on the downcomer wall vertically. (2) If the ECC water column is injected near the broken cold leg, the ECC water is directly bypassed. Thus, the ECC penetration fraction is greatly reduced compared with a typical film type of the horizontal ECC injection. (3) In order to minimize the ECC bypass fraction, the ECC water should be injected toward the wake region of the hot leg blunt bodies.